Hi
I have been using the plugin for a while without any problems, but I have
basically using the plugin to allow Homeseer to arm and disarm the Napco panel.
Recently I have noticed that when I use one of the keypads to arm the system
it doesn't seem to update the status in Homeseer for a while.
Also if I use the keypad to bypass a zone , it doesn't seem to update the status in Homeseer??
Any advice on how to correct this?
Thanks
I have been using the plugin for a while without any problems, but I have
basically using the plugin to allow Homeseer to arm and disarm the Napco panel.
Recently I have noticed that when I use one of the keypads to arm the system
it doesn't seem to update the status in Homeseer for a while.
Also if I use the keypad to bypass a zone , it doesn't seem to update the status in Homeseer??
Any advice on how to correct this?
Thanks
Comment