...actually nothing much is working.
Not sure why there's not a ADIO-100 _hardware_ sub-forum since Homeseer sells this so I'm posting here ... even though it's a hardware problem.
Anyway, I just got it and hooked it up. Problems:
-Left side 5vdc reference to ground shows 5v (no duh)
-Right side 5vdc reference to ground _not_ showing anything (0v); doesn't matter which 5vdc or which ground on the right side (of course I checked the seating of the connector)
-Config'd Bit0 and Bit7 as output; use Dev Mgmt to turn them on; log verifies; zero volts on either bit referenced to Gnd; it should show 12v (I'm assuming; there's not doc)
-Configure Chan7 as input. Tie Analog Chan7 to 5vdc. DevMgr shows blank and no log entry; but...
-If I disconnect that jumper, DevMgr shows 0
There is no documentation so I'm guessing on a few things. LED on unit flashes 4 times then a red flash. What does it mean? Also, in terms of specs, what is the output rated at?
Defective unit? The plug-in appears to work fine.
Thanks.
Tahl
Not sure why there's not a ADIO-100 _hardware_ sub-forum since Homeseer sells this so I'm posting here ... even though it's a hardware problem.
Anyway, I just got it and hooked it up. Problems:
-Left side 5vdc reference to ground shows 5v (no duh)
-Right side 5vdc reference to ground _not_ showing anything (0v); doesn't matter which 5vdc or which ground on the right side (of course I checked the seating of the connector)
-Config'd Bit0 and Bit7 as output; use Dev Mgmt to turn them on; log verifies; zero volts on either bit referenced to Gnd; it should show 12v (I'm assuming; there's not doc)
-Configure Chan7 as input. Tie Analog Chan7 to 5vdc. DevMgr shows blank and no log entry; but...
-If I disconnect that jumper, DevMgr shows 0
There is no documentation so I'm guessing on a few things. LED on unit flashes 4 times then a red flash. What does it mean? Also, in terms of specs, what is the output rated at?
Defective unit? The plug-in appears to work fine.
Thanks.
Tahl
Comment