Announcement

Collapse
No announcement yet.

GoControl WA00Z-1 Z-Wave Wireless Light Switch

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    GoControl WA00Z-1 Z-Wave Wireless Light Switch

    I just purchased a GoControl WA00Z-1 Z-Wave Wireless Light Switch to control a GoControl bulb in a lamp by my bed. I was able to add the z-wave switch to HomeSeer without a problem. The GoControl instructions said to configure the bulb as a group 2 association for the switch. I cannot figure out how to do that in the HomeSeer software. Granted I am new at this and still trying to figure things out. Any advice or suggestions would be helpful.

    #2
    You should be able to setup an event based on the switch going on and then simply add a control device and control the light.
    💁‍♂️ Support & Customer Service 🙋‍♂️ Sales Questions 🛒 Shop HomeSeer Products

    Comment

    Working...
    X