Hi everyone
I'm doing an install of ~30 modules and after installing 10 of them, I'm finding a lot of possible noise interference issue from my fluorescent lights particularly when setting up scenes.
When multiple fluorescent light sets turn on (1 set of light switch can control 5-8 T5 lights for indirect/bounced source) then my 1141 becomes deaf/mute. It either doesn't listen to the respond or the lights stop responding to commands. Even programming scenes can set off unrelated lights: unrelated lights became included with scenes that I'm programming).
Right now I'm waiting for noise absorbers before I continue with the rest of the installation. I really hope these noise absorber will fix my issue, otherwise I'll have 3 dozens useless modules..
Any PLCBUS other users here with good/bad story on electrical interferences? Are they that rare?
I'm doing an install of ~30 modules and after installing 10 of them, I'm finding a lot of possible noise interference issue from my fluorescent lights particularly when setting up scenes.
When multiple fluorescent light sets turn on (1 set of light switch can control 5-8 T5 lights for indirect/bounced source) then my 1141 becomes deaf/mute. It either doesn't listen to the respond or the lights stop responding to commands. Even programming scenes can set off unrelated lights: unrelated lights became included with scenes that I'm programming).
Right now I'm waiting for noise absorbers before I continue with the rest of the installation. I really hope these noise absorber will fix my issue, otherwise I'll have 3 dozens useless modules..
Any PLCBUS other users here with good/bad story on electrical interferences? Are they that rare?
Comment