Hello everyone,
Im sure someone has encountered this problem and hopefully fixed this.
Using an iPad to control Homeseer. And using IRTrans to control my Infrared
devices (TV, setup box, htpc, receiver etc).
Now i've created some screens with remote controls.
I created a screen for my XBMC HTPC.
The buttons are set up using: Homeseer: Run a Homeseer script...
I use: &hs.sendIR "TV,ON"
This works fine.
However, when i try the Up,Down,Left,Right arrow and volume, and press them a few times to navigate...it lags. Like in unworkable.
Some button press do come through, others don't register at all.
I've read some threads that by bypassing Homeseer and using IRTrans directly would greatly improve the performance.
So i've loaded my leared IR commands from homeseer in the IRDB of my IRTrans module. When i connect to my IRTrans module like:
http://192.168.0.xx/send.htm?remote=...nals&command=0
This works fine in my direct browser.
Anyone know how i can put this direct link under a HSTouch button?
I found this thread
http://board.homeseer.com/showthread.php?p=858521
but in essence, this doesn't bypass the homeseer server and i doubt it will get me the desired effect.
Kind Regards,
Michiel
Im sure someone has encountered this problem and hopefully fixed this.
Using an iPad to control Homeseer. And using IRTrans to control my Infrared
devices (TV, setup box, htpc, receiver etc).
Now i've created some screens with remote controls.
I created a screen for my XBMC HTPC.
The buttons are set up using: Homeseer: Run a Homeseer script...
I use: &hs.sendIR "TV,ON"
This works fine.
However, when i try the Up,Down,Left,Right arrow and volume, and press them a few times to navigate...it lags. Like in unworkable.
Some button press do come through, others don't register at all.
I've read some threads that by bypassing Homeseer and using IRTrans directly would greatly improve the performance.
So i've loaded my leared IR commands from homeseer in the IRDB of my IRTrans module. When i connect to my IRTrans module like:
http://192.168.0.xx/send.htm?remote=...nals&command=0
This works fine in my direct browser.
Anyone know how i can put this direct link under a HSTouch button?
I found this thread
http://board.homeseer.com/showthread.php?p=858521
but in essence, this doesn't bypass the homeseer server and i doubt it will get me the desired effect.
Kind Regards,
Michiel
Comment