I have a basic insteon set up going and wanted to change over to homeseer. I have the Hometroller zee. I got it this past Christmas. I purchased a 2413u as a controller and plugged it in. Now when I go in to hsinsteon plug in configuration I get: Error: Cannot find controller. I am not sure how to proceed. I have set the com to usb1 and usb2 and neither worked.
Rkshack
Here is what the log says:
Jun-05 7:49:30 PM Plug-In Finished initializing plug-in HSInsteon
Jun-05 7:49:30 PM HSInsteon ERROR Cannot connect to port: /dev/ttyUSB0
I think by turning off x-10 plug in and then turning on insteon I got it up and running. I can control devices. If I turn x-10 on with cm11a compatability it breaks the insteon and it will stop working. I can get insteon working again by turning off x-10 and restarting insteon. If I try to start x-10 with the ti103/203 mode then it will not get past starting.
Any one can help me?
Rkshack
Rkshack
Here is what the log says:
Jun-05 7:49:30 PM Plug-In Finished initializing plug-in HSInsteon
Jun-05 7:49:30 PM HSInsteon ERROR Cannot connect to port: /dev/ttyUSB0
I think by turning off x-10 plug in and then turning on insteon I got it up and running. I can control devices. If I turn x-10 on with cm11a compatability it breaks the insteon and it will stop working. I can get insteon working again by turning off x-10 and restarting insteon. If I try to start x-10 with the ti103/203 mode then it will not get past starting.
Any one can help me?
Rkshack
Comment