I am not able to get my thermostat to initialize with Homeseer 2. I am getting the following in the log:
8/6/2005 7:26:50 PM RCS X10 Thermostat Warning J Making another attempt to initialize Thermostat Living Room
8/6/2005 7:26:50 PM RCS X10 Thermostat Info J Setting Echo Command Mode for Thermostat Living Room to On
8/6/2005 7:27:15 PM RCS X10 Thermostat Warning J Unable to confirm that Echo Command Mode for Thermostat Living Room was set to On
8/6/2005 7:27:15 PM RCS X10 Thermostat Info J Setting Safe Command Mode for Thermostat Living Room to On
8/6/2005 7:27:41 PM RCS X10 Thermostat Warning J Unable to confirm that Safe Command Mode for Thermostat Living Room was set to On
It appears that I am not getting anything back from the thermostat. But when the thermostat sends out a temp change then Homeseer is receiving that.
Thanks for any help with this.
8/6/2005 7:26:50 PM RCS X10 Thermostat Warning J Making another attempt to initialize Thermostat Living Room
8/6/2005 7:26:50 PM RCS X10 Thermostat Info J Setting Echo Command Mode for Thermostat Living Room to On
8/6/2005 7:27:15 PM RCS X10 Thermostat Warning J Unable to confirm that Echo Command Mode for Thermostat Living Room was set to On
8/6/2005 7:27:15 PM RCS X10 Thermostat Info J Setting Safe Command Mode for Thermostat Living Room to On
8/6/2005 7:27:41 PM RCS X10 Thermostat Warning J Unable to confirm that Safe Command Mode for Thermostat Living Room was set to On
It appears that I am not getting anything back from the thermostat. But when the thermostat sends out a temp change then Homeseer is receiving that.
Thanks for any help with this.
Comment