Hello,
I have both a GEM and an ECM-1240. Initially I had just configured the GEM but needed more circuit coverage so today I also configured the 1240. I'm having a problem where data is received, charted properly and transmitted to SEG correctly for about 6 minutes. Then for six minutes nothing happens, no updates to SEG, no updates of the loads, etc. Then after six minutes it starts working as normal again. I've installed wireshark and can verify that the packets being sent are the same size during the working periods and non-working periods. I haven't been able to decode the packets to inspect the payload.
Any ideas?
Thanks
Ben
I have both a GEM and an ECM-1240. Initially I had just configured the GEM but needed more circuit coverage so today I also configured the 1240. I'm having a problem where data is received, charted properly and transmitted to SEG correctly for about 6 minutes. Then for six minutes nothing happens, no updates to SEG, no updates of the loads, etc. Then after six minutes it starts working as normal again. I've installed wireshark and can verify that the packets being sent are the same size during the working periods and non-working periods. I haven't been able to decode the packets to inspect the payload.
Any ideas?
Thanks
Ben
Comment