Hi all
I have lots of (mostly Fibaro) z-wave devices and am switching from Fibaro's HS2 controller to a Hometroller SEL PRO.
I have been adding my old devices starting with the motion sensors. One of the sensors shows accelerometer devices for each axis, and this device also shows a 100% battery (which I know is not true). All the other motions sensors show 0% battery (which I also know is not true). Every single motion sensor shows 0 lux/luminance.
At least motion seems to be detected OK.
What is going on? I assume the firmware version is different with the three-axis device, but I don't know how to check? Why do none of the batteries or luminance sensors report correctly? I've seen screenshots on the forum where these sensors report everything correctly, so I know it's possible.
I have lots of (mostly Fibaro) z-wave devices and am switching from Fibaro's HS2 controller to a Hometroller SEL PRO.
I have been adding my old devices starting with the motion sensors. One of the sensors shows accelerometer devices for each axis, and this device also shows a 100% battery (which I know is not true). All the other motions sensors show 0% battery (which I also know is not true). Every single motion sensor shows 0 lux/luminance.
At least motion seems to be detected OK.
What is going on? I assume the firmware version is different with the three-axis device, but I don't know how to check? Why do none of the batteries or luminance sensors report correctly? I've seen screenshots on the forum where these sensors report everything correctly, so I know it's possible.
Comment