Hello,
I'm just starting to create my HSTouch screens and have found a an issue with the behaviour of PLCBUS dimmers. Using ON/OFF buttons with PLCBUS dimmers don't take into account what the dimmer % is actualy set to.
Example:
1. Set dimmer to 50%
2. Turn dimmer off
3. Turn dimmer on
4. hSTouch will show dimmer at 100%
Did i configure it wrong? (Status tracking set to the plcbus dimmer address).
Is the value of dimming level stored somewhere else?
I'm just starting to create my HSTouch screens and have found a an issue with the behaviour of PLCBUS dimmers. Using ON/OFF buttons with PLCBUS dimmers don't take into account what the dimmer % is actualy set to.
Example:
1. Set dimmer to 50%
2. Turn dimmer off
3. Turn dimmer on
4. hSTouch will show dimmer at 100%
Did i configure it wrong? (Status tracking set to the plcbus dimmer address).
Is the value of dimming level stored somewhere else?
Comment