Is there any way to add a device address to an existing device.
I have a wall light switch (LINEAR GoControl, WS15Z-1, Zwave Wall Mount Switch) that works with Homeseer Control. Turns on and off using the web site but will not show the status....Status Unknown... I tried removing (excluding) and that re-adding the switch But I can't remove or include it using Z Tool+. The address reads D490CCC0-000 and should read D490CCC0-051.
Thanks...Art
I have a wall light switch (LINEAR GoControl, WS15Z-1, Zwave Wall Mount Switch) that works with Homeseer Control. Turns on and off using the web site but will not show the status....Status Unknown... I tried removing (excluding) and that re-adding the switch But I can't remove or include it using Z Tool+. The address reads D490CCC0-000 and should read D490CCC0-051.
Thanks...Art