Sorry to wind the clock back 5 or 6 (?) years but I had an old HomePro ZIR010 PIR lying around unused and have just tried it out with my new HTZ S2. It works very well and was able to quickly set it up to control a Zwave controlled lamp.
I've one quick question though. On including it to the HTZ it created four devices.
1. ACT On/Off Sensor
2. Battery
3. Notification
4. On-Open-Motion Sensor
It's the latter that seems to change state on detection of motion and controls the associated lamp and #2's use is obvious but what do #1 and #3 do?? In 3 or 4 days of use I haven't seen any return from these.
I've one quick question though. On including it to the HTZ it created four devices.
1. ACT On/Off Sensor
2. Battery
3. Notification
4. On-Open-Motion Sensor
It's the latter that seems to change state on detection of motion and controls the associated lamp and #2's use is obvious but what do #1 and #3 do?? In 3 or 4 days of use I haven't seen any return from these.
Comment