Can anyone shed light on this, please?
I got a couple of these switches and bench tested one that worked just fine, sent and received commands instantly but when I installed them I can ping and control them from HS but, I can't get HS to see their status or they're not sending it, can't work it out.
Checking the log I get this, that I presume is an error of some sort:
Instant status and sensor wake-up notifications are not being programmed because HomeSeer is being used as an installation tool only.
At a guess, it's a setup thing, probably something basic I'm missing.
The manual for the switch is here:
http://www.mcohome.com/upload/file/20180227/20180227144616.pdf
I played about a bit with it and on one of the switches I got it to turn on and off a light and, it *eventually* switched it on but I couldn't get it to switch back off. Send the on/off from HS direct to the switch and it works instantly.
Any ideas?
K.
I got a couple of these switches and bench tested one that worked just fine, sent and received commands instantly but when I installed them I can ping and control them from HS but, I can't get HS to see their status or they're not sending it, can't work it out.
Checking the log I get this, that I presume is an error of some sort:
Instant status and sensor wake-up notifications are not being programmed because HomeSeer is being used as an installation tool only.
At a guess, it's a setup thing, probably something basic I'm missing.
The manual for the switch is here:
http://www.mcohome.com/upload/file/20180227/20180227144616.pdf
I played about a bit with it and on one of the switches I got it to turn on and off a light and, it *eventually* switched it on but I couldn't get it to switch back off. Send the on/off from HS direct to the switch and it works instantly.
Any ideas?
K.
Comment