I read through the sticky for the Keypad linc, but I am not sure everything still applies.
I use to just add the KPL to HomeSeer, then use events to control things and keep the buttons in sync if events controlled the devices/groups. That was/is a little slow.
I decided to try and link the individual devices to the buttons through HS. That sort of worked fine. Now the KPL controls the devices fine, it just gets out of sync if HS events control those same devices. I have the sync responder devices checked in the PI.
How do I get the KPL to stay in sync with the devices it controls?
Thanks,
EDIT: Forgot to state that if I use events to keep the KPL buttons in sync with the devices, sometimes the device will get into a slow on/off cycle. This only happens if the KPL has linked devices and gets updated by events.
I use to just add the KPL to HomeSeer, then use events to control things and keep the buttons in sync if events controlled the devices/groups. That was/is a little slow.
I decided to try and link the individual devices to the buttons through HS. That sort of worked fine. Now the KPL controls the devices fine, it just gets out of sync if HS events control those same devices. I have the sync responder devices checked in the PI.
How do I get the KPL to stay in sync with the devices it controls?
Thanks,
EDIT: Forgot to state that if I use events to keep the KPL buttons in sync with the devices, sometimes the device will get into a slow on/off cycle. This only happens if the KPL has linked devices and gets updated by events.
Comment