Posting back to plugin web page ZWaveControllers: Object reference not set to an instance of an object.-> at System.Runtime.Remoting.Messaging.LogicalCallContext.Propaga teIncomingHeadersToCallContext(IMessage msg) at System.Runtime.Remoting.Proxies.RealProxy.PrivateInvoke(Mess ageData& msgData, Int32 type) at HomeSeerAPI.IPlugInAPI.PostBackProc(String page, String data, String user, Int32 userRights) at Scheduler.proxyPage.postBackProc(StateObject& state, String Data)
Eventually it comes back or I have to restart the controller manually.
I really cannot use a system like this if it's so flaky to the point the Fibaro HC2 had been far more reliable - the most I got with that system was sensors not always waking up but it never once crashed like this is doing.
I have factory reset the controller 3 times, excluded/included all the devices an equal amount of times but get to the same issue.
All the motion detectors have been excluded and hard reset too.
Any advice?
At this point, I am willing to waste maybe tomorow resolving it but failing that, the HS ethernet thing will be going back and having just bought a Microserver, I will probably go back to using the z-stick.
I have since typing this got the two Aeotec multi6 sensors added by plugging them in (rather than running USB), adding them and all of the bits that make up the sensor added in fine.
First one I changed the settings to enable motion etc without issues.
Second one added fine but going into the root device brings back the below again and slows down everything until the controllers finished throwing a tantrum.
Posting back to plugin web page ZWaveControllers: Object reference not set to an instance of an object.-> at System.Runtime.Remoting.Messaging.LogicalCallContext.Propaga teIncomingHeadersToCallContext(IMessage msg) at System.Runtime.Remoting.Proxies.RealProxy.PrivateInvoke(Mess ageData& msgData, Int32 type) at HomeSeerAPI.IPlugInAPI.PostBackProc(String page, String data, String user, Int32 userRights) at Scheduler.proxyPage.postBackProc(StateObject& state, String Data)
Thanks in advance
Eventually it comes back or I have to restart the controller manually.
I really cannot use a system like this if it's so flaky to the point the Fibaro HC2 had been far more reliable - the most I got with that system was sensors not always waking up but it never once crashed like this is doing.
I have factory reset the controller 3 times, excluded/included all the devices an equal amount of times but get to the same issue.
All the motion detectors have been excluded and hard reset too.
Any advice?
At this point, I am willing to waste maybe tomorow resolving it but failing that, the HS ethernet thing will be going back and having just bought a Microserver, I will probably go back to using the z-stick.
I have since typing this got the two Aeotec multi6 sensors added by plugging them in (rather than running USB), adding them and all of the bits that make up the sensor added in fine.
First one I changed the settings to enable motion etc without issues.
Second one added fine but going into the root device brings back the below again and slows down everything until the controllers finished throwing a tantrum.
Posting back to plugin web page ZWaveControllers: Object reference not set to an instance of an object.-> at System.Runtime.Remoting.Messaging.LogicalCallContext.Propaga teIncomingHeadersToCallContext(IMessage msg) at System.Runtime.Remoting.Proxies.RealProxy.PrivateInvoke(Mess ageData& msgData, Int32 type) at HomeSeerAPI.IPlugInAPI.PostBackProc(String page, String data, String user, Int32 userRights) at Scheduler.proxyPage.postBackProc(StateObject& state, String Data)
Thanks in advance
Comment