Hi, I created a virtual device called Door Close Cancel. When the device is set to on, it should prevent our garage doors from closing- yet it didn't... I can't figure what I am missing??
-
-
Try adding the AND IF to both triggers. -
Or put the cancel flag first so it exits before seeing the rest of the events.
I did this for a GDO open TTS dialog in case I was working in the garage with the door open.- Pete
Auto matorHomeseer 3 Pro - 3.0.0.548 (Linux) - Ubuntu 18.04/W7e 64 bit Intel Haswell CPU 16Gb
Homeseer Zee2 (Lite) - 3.0.0.548 (Linux) - Ubuntu 18.04/W7e - CherryTrail x5-Z8350 BeeLink 4Gb BT3 Pro
HS4 Lite - Ubuntu 22.04 / Lenovo Tiny M900 / 32Gb Ram
HS4 Pro - V4.1.18.1 - Ubuntu 22.04 / Lenova Tiny M900 / 32Gb Ram
HSTouch on Intel tabletop tablets (Jogglers) - Asus AIO - Windows 11X10, UPB, Zigbee, ZWave and Wifi MQTT automation-Tasmota-Espurna. OmniPro 2, Russound zoned audio, Alexa, Cheaper RFID, W800 and Home AssistantComment
-
In your first IF statement you also have to include your AND.
If Door has been open for ...
And if device is off
Or if Door2 has been open for ...
And if device is off
Then ...MichaelComment
-
Thanks Everyone!
Michael, I didn't realize you had to have the "And" on both...
All were good suggestions.Comment
-
RPrade has done some excellent write ups on events.
Look at this thread: https://forums.homeseer.com/showthread.php?t=173196MichaelComment
Comment