Thank you for speaking to the manufacturer. Is there a later firmware that supports configurations as the product literature indicates?
My associations for the dual channel relay controlling light 1 are set as shown in the picture below.
Enerwave technical support told me to add Group 3 endpoint 2. Before that it only had groups 1 and 2, but was otherwise identical to what you see now.
Before adding group 3 I could turn one light on or off via the app and the other light would respond as I had programmed the Zee2, but when a light was triggered on by motion it did not report to the Zee2 and the other light would not respond.
After I added group 3, when light 1 was triggered on by motion, light 2 also went on like I wanted and the controller usually saw that both lights were on. However, when light 1 goes off because no motion is detected, light 2 does not go off and the controller still thinks both lights are on.
In addition, while light 1 will go off after a minute when no motion is detected, light 2 will stay on indefinitely unless I use the app to turn it off manually, so something is keeping it from going off.
Finally, after light 1 is triggered on by motion, I cannot turn it off with the app. It flashes and goes right back on.
My associations for the dual channel relay controlling light 1 are set as shown in the picture below.
Enerwave technical support told me to add Group 3 endpoint 2. Before that it only had groups 1 and 2, but was otherwise identical to what you see now.
Before adding group 3 I could turn one light on or off via the app and the other light would respond as I had programmed the Zee2, but when a light was triggered on by motion it did not report to the Zee2 and the other light would not respond.
After I added group 3, when light 1 was triggered on by motion, light 2 also went on like I wanted and the controller usually saw that both lights were on. However, when light 1 goes off because no motion is detected, light 2 does not go off and the controller still thinks both lights are on.
In addition, while light 1 will go off after a minute when no motion is detected, light 2 will stay on indefinitely unless I use the app to turn it off manually, so something is keeping it from going off.
Finally, after light 1 is triggered on by motion, I cannot turn it off with the app. It flashes and goes right back on.
Comment