Hi,
I've been using Homeseer for a while now, but I am new to the forums.
I have just connected up an Arduino UNO with Ethernet Shield to HS3. Digital Inputs and Outputs are working correctly, however I cannot get any joy out of the Analog Inputs.
With a basic setup of a potentiometer as per the instruction manual, the reading in HS3 is only ever '0', regardless of the state of the pot. The setup works correctly within the Arduino IDE whilst running AnalogReadSerial, so I presume there is something odd going on with the plugin.
I am running V1.0.0.131, IDE V1.6.8.
Any ideas what I maybe doing incorrectly!?
Toby
I've been using Homeseer for a while now, but I am new to the forums.
I have just connected up an Arduino UNO with Ethernet Shield to HS3. Digital Inputs and Outputs are working correctly, however I cannot get any joy out of the Analog Inputs.
With a basic setup of a potentiometer as per the instruction manual, the reading in HS3 is only ever '0', regardless of the state of the pot. The setup works correctly within the Arduino IDE whilst running AnalogReadSerial, so I presume there is something odd going on with the plugin.
I am running V1.0.0.131, IDE V1.6.8.
Any ideas what I maybe doing incorrectly!?
Toby
Comment