Announcement

Collapse
No announcement yet.

Multiple LED strips into one Fibaro RGB controler without daisy chaining?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Multiple LED strips into one Fibaro RGB controler without daisy chaining?

    Does anyone know if you can run two strips out of a Fibaro RGB module directly, instead of daisy chaining them?

    So you'd have two red wires, two green, two blue, and two power going into the terminal block of the Fibaro, using a single power source?

    #2
    Yes, I've got 2 wired that way.

    Actually, daisy chaining is exactly the same. The strips are wired in parallel but at the end of a long wire, rather than at the module.

    Comment


      #3
      One thing with daisy chaining (I take it you mean wiring it to the end of an existing length of them) though is you may have a volt drop along the length (depending on the length and a couple of other things) so when you are at the end of the length you might be at a lower voltage and end up with the lengths getting dimmer the more you daisy chain.

      Comment


        #4
        cool... thanks all!

        Comment

        Working...
        X