Hi All,
Help!
Been using HS3/Z wave for a while now, but a little stumped.
Purchased the new Popp smoke detector but having install issues. Using with the Aeon z stick as controller
Unit installs OK (screenshot below) but does not retain node I.D. Have included/excluded numerous times now but cannot get it to retain node I.D. Ive also looked in the z wave controller management section, it also appears there too but not for long. Is there a .dbfile or something I can edit or check?
I have tried network scan/health check and all others!
Guidance appreciated
Help!
Been using HS3/Z wave for a while now, but a little stumped.
Purchased the new Popp smoke detector but having install issues. Using with the Aeon z stick as controller
Unit installs OK (screenshot below) but does not retain node I.D. Have included/excluded numerous times now but cannot get it to retain node I.D. Ive also looked in the z wave controller management section, it also appears there too but not for long. Is there a .dbfile or something I can edit or check?
I have tried network scan/health check and all others!
Guidance appreciated
Comment