I added a second Ztroller to my system to better reach some distant devices. I didn't think to reset it (clean it up) before I started and don't know what was on it, I simply connected it via serial port, added it as Remote Interface 1 and then changed the "Interface to Use" on 8 devices from the Main Interface to the new Remote Interface. I then optimized 4 or 5 times on the devices and then the network. Everything seems to work well and I seem to have good control of my network.
PROBLEM: My ZSeer, which previously showed 95% blue connections, now shows lots of red and yellow lines. I travel a lot and hate to see what appears to be a compromised network. Each time I optimize I get this message in the log for only the devices I moved to the new Remote Interface:
7/13/2013 10:47:23 PM Warning A Z-Wave interface on the system is being restarted - some Z-Wave signals could be missed.
7/13/2013 10:47:23 PM Warning Unable to optimize node 41, Int Light Master Foyer Lights, there was no indication that the node neighbor update started.
7/13/2013 10:46:08 PM Z-Wave Instructing node # 41,Int Light Master Foyer Lights, to re-discover its neighbors using interface Den...
Any ideas?
PROBLEM: My ZSeer, which previously showed 95% blue connections, now shows lots of red and yellow lines. I travel a lot and hate to see what appears to be a compromised network. Each time I optimize I get this message in the log for only the devices I moved to the new Remote Interface:
7/13/2013 10:47:23 PM Warning A Z-Wave interface on the system is being restarted - some Z-Wave signals could be missed.
7/13/2013 10:47:23 PM Warning Unable to optimize node 41, Int Light Master Foyer Lights, there was no indication that the node neighbor update started.
7/13/2013 10:46:08 PM Z-Wave Instructing node # 41,Int Light Master Foyer Lights, to re-discover its neighbors using interface Den...
Any ideas?
Comment