Hi,
I have two Insteon dimmers in a double gang junction box. Sometimes I tap both of them Off at the same time. Just today, I noticed that HS only saw one of the switches get set to Off, and surprisingly it was the one that was already Off.
I've been experiencing a symptom of this problem for a long time and it wasn't until now that I realized why.
I could kind of understand why this might happen but I was hoping the devices and/or PLM would be smart enough to detect simultaneous transmission and try again. Or perhaps they are and the plugin is skipping them...I haven't enabled detailed logging to check yet. I was hoping someone has experienced this before and can tell me it's expected, or has a solution. If not, I'll check those logs.
Thanks!
I have two Insteon dimmers in a double gang junction box. Sometimes I tap both of them Off at the same time. Just today, I noticed that HS only saw one of the switches get set to Off, and surprisingly it was the one that was already Off.
I've been experiencing a symptom of this problem for a long time and it wasn't until now that I realized why.
I could kind of understand why this might happen but I was hoping the devices and/or PLM would be smart enough to detect simultaneous transmission and try again. Or perhaps they are and the plugin is skipping them...I haven't enabled detailed logging to check yet. I was hoping someone has experienced this before and can tell me it's expected, or has a solution. If not, I'll check those logs.
Thanks!
Comment