Announcement

Collapse
No announcement yet.

Adding third (neutral) wire to two-wire Z-Wave switches

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Adding third (neutral) wire to two-wire Z-Wave switches

    On a two-wire Z-Wave dimmer the ground of the internal control circuit is grounded through the controlled resistive load. This works great if you have an incandescent load but not if you are running low current LEDs.

    Has anyone modified a two-wire switch by adding a neutral so that the switch would work again with low current loads?

    Thanks!!!


    ~Bill
Working...
X