Mark,
I have 3-way switches that behave strangely. Switch 'A' has physical load control and 'B' is the slave. Both definitions have 'Sync linked responder devices' checked and identical settings.
If I ask the plugin to set device 'A' to DIM 40%:
If I ask the plugin to set device 'B' to DIM 40%:
So, different behavior depending on which switch is activated and LED strips are not synchronized.
On a detailed log, I see the plugin sending the first light '01 66', then '2E FF' to the linked responder device.
My objective: to get the LED strips synchronized at 40%. What do I need to do to achieve this?
I have 3-way switches that behave strangely. Switch 'A' has physical load control and 'B' is the slave. Both definitions have 'Sync linked responder devices' checked and identical settings.
If I ask the plugin to set device 'A' to DIM 40%:
- the light comes On at 40% at the default ramp rate of 4 secs
- the LED strip on switch 'A' shows 40%
- the LED strip on switch 'B' shows 100%
If I ask the plugin to set device 'B' to DIM 40%:
- the light comes On at 100% at an apparent ramp rate of .5 sec
- the LED strip on switch 'A' shows 100%
- the LED strip on switch 'B' shows 40%
So, different behavior depending on which switch is activated and LED strips are not synchronized.
On a detailed log, I see the plugin sending the first light '01 66', then '2E FF' to the linked responder device.
My objective: to get the LED strips synchronized at 40%. What do I need to do to achieve this?
Comment