I just did a fresh install of Win7 Home Premium.
I am now trying fruitlessly to get HS2 to work with INSTEON and X-10 devices that worked under XP.
My Insteon/X-10 network consists of:
1. linked (to each other) access points on different phases on different floors of the house.
2. 2414U (FW:2.13), USB PLC
3. About 10 Insteon devices
4. About 10 X-10 devices
I have installed HS2 and did an immediate upgrade to 2.4.0.11 (current as of this writing). I used the PLC and it shows up as 1.1.52.1
No matter what I try, I am unable to communicate with any other device period...X10 or INSTEON.
I have been (and still am) searching for viable solutions, but as of yet have not found any.
Does anyone have any clue as to why I am having such difficulty?
I have all the Device ID's. I have tried tap-adding and manual-adding. Neither way produces any results...unable to communicate.
More info, log file and results after trying to manually add a device:
Insteon Plug-in Configuration - HYBRID PLC VERSION 1.1.52.1 In PLC/SDM Mode
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
The Insteon device at 07.CC.4D did not respond. Please check to make sure the address is correct and that the device is powered-up. The device was not registered.
Thanks.
--tmac
I am now trying fruitlessly to get HS2 to work with INSTEON and X-10 devices that worked under XP.
My Insteon/X-10 network consists of:
1. linked (to each other) access points on different phases on different floors of the house.
2. 2414U (FW:2.13), USB PLC
3. About 10 Insteon devices
4. About 10 X-10 devices
I have installed HS2 and did an immediate upgrade to 2.4.0.11 (current as of this writing). I used the PLC and it shows up as 1.1.52.1
No matter what I try, I am unable to communicate with any other device period...X10 or INSTEON.
I have been (and still am) searching for viable solutions, but as of yet have not found any.
Does anyone have any clue as to why I am having such difficulty?
I have all the Device ID's. I have tried tap-adding and manual-adding. Neither way produces any results...unable to communicate.
More info, log file and results after trying to manually add a device:
Insteon Plug-in Configuration - HYBRID PLC VERSION 1.1.52.1 In PLC/SDM Mode
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
The Insteon device at 07.CC.4D did not respond. Please check to make sure the address is correct and that the device is powered-up. The device was not registered.
Thanks.
--tmac
Comment