Announcement

Collapse
No announcement yet.

How do I migrate from Z-Net to USB Zwave ?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    #16
    Looking at your node info, it would appear that Node 39 doesn't have any neighbours (which is strange) and Node 30 only has 2. If Z-Wave can't find a communication route between 2 devices then you will see failures.

    I think you have given me access to your HS system before. If you want to email me some temporary credentials etc (I think you have my email address), I have an hour spare and I'm happy to take a look for you and see if I can spot anything out of the ordinary.

    I'm inclined to think that this is a config issue as opposed to controller failure.

    Paul..

    Comment


      #17
      @mike123 When you moved over from Vera, do you transfer devices, or did you do a clean install?

      Comment


        #18
        Paul I will send an email with access. I have just run a network optimisation, and the nodes are contactable again. When you log in, please ignore the following as they are temporarily unplugged:

        Optimizing node 46 (Node 46 Z-Wave Fibaro On/Off Sensor)...
        Done. The optimization was not executed as the node cannot be reached.
        ...
        Node 46 Neighbor Status: 4 Neighbors: 1, 48, 63, 79
        ------------------------------------------------------
        Optimizing node 48 (Node 48 Z-Wave Fibaro On/Off Sensor)...
        ...
        Done. The optimization was not executed as the node cannot be reached.
        Node 48 Neighbor Status: 7 Neighbors: 1, 46, 60, 62, 63, 77, 79

        Optimizing node 74 (Lights Garden Tree root)...
        Done. The optimization was not executed as the node cannot be reached.
        ...
        Node 74 Neighbor Status: One Neighbor: 62
        ------------------------------------------------------
        Optimizing node 76 (Lights Garden Reindeer root)...
        ...
        Done. The optimization was not executed as the node cannot be reached.
        Node 76 Neighbor Status: One Neighbor: 62
        ------------------------------------------------------
        Optimizing node 77 (Lights Lounge Xmas tree root)...
        Done.
        Node 77 Neighbor Status: 18 Neighbors: 2, 3, 7, 11, 12, 19, 20, 26, 28, 30, 31, 38, 42, 48, 49, 52, 62, 63



        I think I moved my network over from Vera, had a few issues and I think I started again but not 100% sure as its a while ago

        Comment

        Working...
        X