In BLDSC(ver1.0.20), can we not change the Floor/Room settings of the Partition Arm/Disarm Status device? I've been able to change the Floor/Room settings for Zone devices without any issues. But when I changed the Partition devices to a different Room than the default "BLDSC" the plug-in re-created the Partitions Devices again after a restart of HomeSeer. My Partition Devices are doubling with each restart of HomeSeer?
Also, trying to figure out why the status images aren't showing up? This is a brand new install of both HomeSeer & BLDSC.
Thanks for any help you can provide.
Also, trying to figure out why the status images aren't showing up? This is a brand new install of both HomeSeer & BLDSC.
Thanks for any help you can provide.
Comment