Helo,
I just started using this with HS3 and I don't know all the syntax needed to send commands to HS. I am trying this:
ML2HS|HS-SetDeviceValue~E1~100
But the device in HS isn't changing. Is there a command list somewhere? I tried the command builder in MLServer, but that was confusing.
Thank you.
I just started using this with HS3 and I don't know all the syntax needed to send commands to HS. I am trying this:
ML2HS|HS-SetDeviceValue~E1~100
But the device in HS isn't changing. Is there a command list somewhere? I tried the command builder in MLServer, but that was confusing.
Thank you.
Comment