I wonder if anyone can shed any light - I have recently converted my stats all to the RCS RS485 from the RCS X10 - long story. Anyhow, I have three of them, connected to a pre-existing damper panel, and the RCS active RCS 485 hub. Have installed the plugin and it displays status properly as well as I can manually control the stats through homeseer interface.
I have set the config screen to be in Celsius rather than Fahrenheit - problem is now I have gone in to try and start programming some triggers etc. with the plugin and the numerical scale provided is obviously in Fahrenheit (as it does not drop down low enough).
Does anyone know if this is a software limitation requiring attention, or if it is simply a config setting I must adjust?
Any help is appreciated.
CF
I have set the config screen to be in Celsius rather than Fahrenheit - problem is now I have gone in to try and start programming some triggers etc. with the plugin and the numerical scale provided is obviously in Fahrenheit (as it does not drop down low enough).
Does anyone know if this is a software limitation requiring attention, or if it is simply a config setting I must adjust?
Any help is appreciated.
CF
Comment