Ok all,
This would be a nice how to as I know I have set this up before with help of others but now and then i forget how to do it. Building a new machine and going to start over so I will be trying to figure this one out again..
example is I open my garage door... (concord 4 door sensor)
door opens - event turns lights on and trips motion (didnt before but if you dont walk in room light stays on so trip it)
You walk around and the lights never turn off
when you leave they turn off.
i remember it has to do with one manual event that is deleted then ran in x minutes... keeps checking and the sort..
anyway possibly a how to for this?
This would be a nice how to as I know I have set this up before with help of others but now and then i forget how to do it. Building a new machine and going to start over so I will be trying to figure this one out again..
example is I open my garage door... (concord 4 door sensor)
door opens - event turns lights on and trips motion (didnt before but if you dont walk in room light stays on so trip it)
You walk around and the lights never turn off
when you leave they turn off.
i remember it has to do with one manual event that is deleted then ran in x minutes... keeps checking and the sort..
anyway possibly a how to for this?
Comment