I have a fairly new ADIO-100 that isn't working reliably. I have it hooked to 5 magnetic door switches. The switches are made by three different manufactures three are set to normally open and two are set to normally closed. None of the ports on the ADIO-100 show the correct status consistently. When I open one of the doors with the normally closed switch my HS3 device status page will most of the time show the door changing from closed to open. When I close the door most of the time it will not show the status change. Sometimes the status changes on a door or window that hasn't been opened. Sometimes opening one of the doors will cause a change on another door or window status. Usually I will get a error message on the log when the status fails to change it is - "ADIO-100 error decoding from 0: Index was out of range. Must be non-negative and less than the size of the collection. Parameter name: startIndex" Any idea what that really means?
I have connected the door sensors to the ADIO-100 digital port Bit-0, Bit-1, Bit-2, Bit-3, and Bit-4 using the +5 volt connectors for sensing power. I have them set for input and status only. On the normally closed switches I'm looking for a value of 0 when the door is open and 5 when closed. The device status usually shows Open "0" immediately when I open the door with no error message. Sometimes I get a Closed "5" status sort of quickly with no error message. Most of the time I don't see the status change from Open "0" when I close the door. Then when I check the log I see the above error message. Sometimes later I may get the status Closed "5". I'm using a cat 5 network wire for connecting to the door and window switches and normally these wires are immune from outside interference. I'm only using on of the four pairs of wires.
I have tried adding a check or codes 1 2 3 and 4 in addition to checking for code 5, That didn't help.
I sent a E-Mail to HomeSeer and they say it must be a door switch issue.
Any thoughts?
I have connected the door sensors to the ADIO-100 digital port Bit-0, Bit-1, Bit-2, Bit-3, and Bit-4 using the +5 volt connectors for sensing power. I have them set for input and status only. On the normally closed switches I'm looking for a value of 0 when the door is open and 5 when closed. The device status usually shows Open "0" immediately when I open the door with no error message. Sometimes I get a Closed "5" status sort of quickly with no error message. Most of the time I don't see the status change from Open "0" when I close the door. Then when I check the log I see the above error message. Sometimes later I may get the status Closed "5". I'm using a cat 5 network wire for connecting to the door and window switches and normally these wires are immune from outside interference. I'm only using on of the four pairs of wires.
I have tried adding a check or codes 1 2 3 and 4 in addition to checking for code 5, That didn't help.
I sent a E-Mail to HomeSeer and they say it must be a door switch issue.
Any thoughts?
Comment