I just setup a Foscam F18918W camera and when I turned on my WFTT07-2 Control Pad and clicked on the camera tab it immediately started streaming the video. However the Pan & Tilt buttons are disabled and it says these controls only work with a pan/tilt camera which this is. I can operate it just fine in the Foscam app. I read in one of the posts somewhere where Mark (pretty sure it was him) said HSTouch automatically finds the cameras which it did. Why doesn't it recognize the pan/tilt aspect? Do I need to do something else?
If this is your first visit, be sure to check out the FAQ. You must register before you can post.
IMPORTANT: Your first post will be checked for appropriate content. This may take a bit of time.
- If your post is deemed to be spam-free and relevant to the community, it will be approved and you'll be able to post freely here.
- If your post is deemed to be spam, your post will be deleted and your account will be permanently banned.
Comment