UJ:
Forgive me if this is known behavior, but,
This past weekend, one of the water sensors tied to my M1 (under a sink) detected a water leak and shut the main water OFF - so that was good!
BUT --
I didn't get any notice of the Water Alarm other than from the M1 itself; the HS3 Event I wrote to notify me via email and text did not do anything. The event was looking for a change in state of Area 1's AreaStatus 03 [Area 1 Current Alarm State]. Just to see if this was a fluke, tonight I disabled the UltraM1G3 plugin, power cycled the M1 and re-enabled the plugin; then I intentionally made one of the water sensors "fire up". The M1 responded as it should. As you can see from the HS3 screen snippet below, the UltraM1G3 plug-in is getting some indication of the activity because it shows up in the LOG tab of the plugin:
But the Area 1 AreaStatus 03 did not change. What am I doing wrong? I would think that status field/device would change whenever there is an alarm. I'm running version 3.0.6551.16372 of the plugin on Ubuntu Linux 16.04 LTS. Any help / guidance would be much appreciated.
Regards,
BBB
Forgive me if this is known behavior, but,
This past weekend, one of the water sensors tied to my M1 (under a sink) detected a water leak and shut the main water OFF - so that was good!
BUT --
I didn't get any notice of the Water Alarm other than from the M1 itself; the HS3 Event I wrote to notify me via email and text did not do anything. The event was looking for a change in state of Area 1's AreaStatus 03 [Area 1 Current Alarm State]. Just to see if this was a fluke, tonight I disabled the UltraM1G3 plugin, power cycled the M1 and re-enabled the plugin; then I intentionally made one of the water sensors "fire up". The M1 responded as it should. As you can see from the HS3 screen snippet below, the UltraM1G3 plug-in is getting some indication of the activity because it shows up in the LOG tab of the plugin:
But the Area 1 AreaStatus 03 did not change. What am I doing wrong? I would think that status field/device would change whenever there is an alarm. I'm running version 3.0.6551.16372 of the plugin on Ubuntu Linux 16.04 LTS. Any help / guidance would be much appreciated.
Regards,
BBB
Comment