mcsTemperature does not support the DS2409 which is typically used as a 1-wire hub switch. I am not aware of any direct HS plugins that suport this device, but it can be used with Homeseer via xapmcs1Wire which does support the DS2409. It is likely that all your sensors are connected through your hub and not visible directly to the DS9490D.
To use xapmcs1wire http://board.homeseer.com/showthread.php?t=101056 you need to setup an xAP environment using mcsXap plugin to make the interface into Homeseer. The environment includes an xAP hub which is also available in the same area of the message board as xapmcs1wire. xapmcs1wire is a .NET application so a different set of drivers for 1-wire will also be needed.
To use xapmcs1wire http://board.homeseer.com/showthread.php?t=101056 you need to setup an xAP environment using mcsXap plugin to make the interface into Homeseer. The environment includes an xAP hub which is also available in the same area of the message board as xapmcs1wire. xapmcs1wire is a .NET application so a different set of drivers for 1-wire will also be needed.
Comment