I just picked up a dual-band 2413U PLM. I also got the Insteon adapter for my Venstar thermostat and 2420M motion detector. Unfortunately, I cannot get them to link!
I set Homeseer to tap-add and proceeded to put the motion detector into link mode. No joy. I was only 3 feet away from the PLM, so it was not an issue with range.
The only thing I can think of is that the 2413 PLM cannot link over RF. I don't see anything in the quick-start guide to confirm or deny this. I'd prefer not to buy a $40 access point or a $50 dual-band lamp module just to link devices!
Any thoughts?
Thanks,
Chris
I set Homeseer to tap-add and proceeded to put the motion detector into link mode. No joy. I was only 3 feet away from the PLM, so it was not an issue with range.
The only thing I can think of is that the 2413 PLM cannot link over RF. I don't see anything in the quick-start guide to confirm or deny this. I'd prefer not to buy a $40 access point or a $50 dual-band lamp module just to link devices!
Any thoughts?
Thanks,
Chris
Comment