Installation Instructions:
1) Click Plug-Ins > Manage.
2) Click the + icon next to Additional Interfaces.
3) Under Security Panel Plug-Ins, click the checkbox under Install.
4) Under Pending Updates/Installs, click Download and Install.
5) Once installed, you'll need to click Enabled, then Disabled, then Enabled again (appears to be a HomeSeer3 bug).
5) Click Plug-Ins > UltraM1G3 > UltraM1G3, then click the Options tab.
6) Under Elk M1G Connectivity, select your connection type (Ethernet or Serial), the specify either the serial port or IP address.
7) Under Defined Elk M1G Configuration, select the number of areas, keypads, users, zones, outputs, thermostats, custom values, counters, tasks, Lighting, then click Save.
8) From Plug-Ins > Manage, click Enable (to disable it), then Enable again. If the connection options are set correctly, the plug-in will perform an initial full load and will build a connection device indicating if the panel connection was successful.
9) At this point, you should be able to create any of the supported HomeSeer devices by clicking Plug-Ins > UltraM1G3 > UltraM1G3.
Please post any issues in this thread.
Regards,
Ultrajones
1) Click Plug-Ins > Manage.
2) Click the + icon next to Additional Interfaces.
3) Under Security Panel Plug-Ins, click the checkbox under Install.
4) Under Pending Updates/Installs, click Download and Install.
5) Once installed, you'll need to click Enabled, then Disabled, then Enabled again (appears to be a HomeSeer3 bug).
5) Click Plug-Ins > UltraM1G3 > UltraM1G3, then click the Options tab.
6) Under Elk M1G Connectivity, select your connection type (Ethernet or Serial), the specify either the serial port or IP address.
7) Under Defined Elk M1G Configuration, select the number of areas, keypads, users, zones, outputs, thermostats, custom values, counters, tasks, Lighting, then click Save.
8) From Plug-Ins > Manage, click Enable (to disable it), then Enable again. If the connection options are set correctly, the plug-in will perform an initial full load and will build a connection device indicating if the panel connection was successful.
9) At this point, you should be able to create any of the supported HomeSeer devices by clicking Plug-Ins > UltraM1G3 > UltraM1G3.
Please post any issues in this thread.
Regards,
Ultrajones
Comment