Hi all,
I just got an Aeon Minimote and just thought I’d share how I set it up with my Homeseer Zee since it was really hard to find any kind of information other than a few posts on here which were a little off and way too long. Also, keeping things simple, I’ve included screenshots of a simple way to use one button to turn a light on and off with an event, but obviously you can do a lot more!
Step 1
Make sure you reset all the settings in your remote by holding down the Associate and Learn buttons (v2 Minimote), or the blank button and join buttons (v1 Minimote) for 10+ seconds. You’ll see some sort of LED countdown timer on the remote where the red and blue buttons will flash back and forth faster and faster, then they will both go dark indicating a successful reset.
Step 2
Make sure you are in normal range of your Z-Wave interface.
Go to PLUG-INS -> Z-Wave -> Controller Management
Click on the arrow next to your Z-Wave Interface
Under actions, select Add/Include a Node, then click the Start button.
Press the Learn button on your remote (or the Join button on the v1 remote). You should see the LED’s blink on the Minimote while it is communicating with your Z-Wave interface, and the remote added as a new node in the Homeseer log window.
It’s that easy!
Now, you’ll see a new node that looks like this (Button 1 Pressed is the last status):
Clicking on the node, you’ll see this:
To turn a light on and off with a single button:
I just got an Aeon Minimote and just thought I’d share how I set it up with my Homeseer Zee since it was really hard to find any kind of information other than a few posts on here which were a little off and way too long. Also, keeping things simple, I’ve included screenshots of a simple way to use one button to turn a light on and off with an event, but obviously you can do a lot more!
Step 1
Make sure you reset all the settings in your remote by holding down the Associate and Learn buttons (v2 Minimote), or the blank button and join buttons (v1 Minimote) for 10+ seconds. You’ll see some sort of LED countdown timer on the remote where the red and blue buttons will flash back and forth faster and faster, then they will both go dark indicating a successful reset.
Step 2
Make sure you are in normal range of your Z-Wave interface.
Go to PLUG-INS -> Z-Wave -> Controller Management
Click on the arrow next to your Z-Wave Interface
Under actions, select Add/Include a Node, then click the Start button.
Press the Learn button on your remote (or the Join button on the v1 remote). You should see the LED’s blink on the Minimote while it is communicating with your Z-Wave interface, and the remote added as a new node in the Homeseer log window.
It’s that easy!
Now, you’ll see a new node that looks like this (Button 1 Pressed is the last status):
Clicking on the node, you’ll see this:
To turn a light on and off with a single button:
Comment