Status Graphics

[ChrisH]

I upgraded to version 2 of the plugin and everything is operational.

The only problem I had with it was that it reset all my custom status graphics for each light / group back to the defaults. I used the HomeSeer built in luminance graphics which made the light show nicely on the HSTouch screens.

Below are the values that I used for each light / group. Is there any way I can restore the status graphics for each light to the values they were before the plugin upgrade? I was quite a lot of work for me to enter all that in. Or perhaps there is a script I could run for each device to update the status graphics in bulk to my standard set?

Hopefully there is a way!
thank you

Value: -1
Graphic Path: images/HomeSeer/contemporary/red.png

Value: 0
Graphic Path: images/HomeSeer/contemporary/luminance-00.png

Value: 1 - 23
Graphic Path: images/HomeSeer/contemporary/luminance-6-25.png

Value: 24 - 46
Graphic Path: images/HomeSeer/contemporary/luminance-18-75.png

Value: 47 - 69
Graphic Path: images/HomeSeer/contemporary/luminance-25.png

Value: 70 - 92
Graphic Path: images/HomeSeer/contemporary/luminance-31-25.png

Value: 93 - 115
Graphic Path: images/HomeSeer/contemporary/luminance-43-75.png

Value: 116 - 138
Graphic Path: images/HomeSeer/contemporary/luminance-50.png

Value: 139 - 161
Graphic Path: images/HomeSeer/contemporary/luminance-56-25.png

Value: 162 - 184
Graphic Path: images/HomeSeer/contemporary/luminance-68-75.png

Value: 185 - 207
Graphic Path: images/HomeSeer/contemporary/luminance-75.png

Value: 208 - 230
Graphic Path: images/HomeSeer/contemporary/luminance-81-25.png

Value: 231 - 253
Graphic Path: images/HomeSeer/contemporary/luminance-93-75.png

Value: 254 - 255
Graphic Path: images/HomeSeer/contemporary/luminance-100.png

[w.vuyk]

Chris,

The plugin was updating the status graphics for the addition of new light types and groups. With standard upgrades it should not update them, other then when you choose to use the different option for dim percentage or full range.
Be aware that if you choose to use dim values in percentage or otherwise remove the percentage option the plugin will set the graphic pairs again.

I found a thread on the graphic pairs here to get you started

Thanks,

Wim

[ChrisH]

Wim, thank you for the reply and link. That looks useful and I will give it a go. I understand about the minor / major plugin updates.