Good news Andrew!
I see that you were most concerned about the Z-Wave stuff / back up.
Here base lighting network is UPB (two HS3 boxes and OP2). Z-Wave connectivity is via the GPIO z-wave card on an RPi2 and the Leviton VRCOP (connected to the Omni Pro2). X-10 on two HS3 boxes and OP2. (also utilize Zigbee).
Main heartbeat of home automated events are on the OmniPro2. Granular stuff is on the two HS3 boxes. IE: if HS3 stops; lighting schedules and scenes continue to work.
Here primarily just back up the HS3 directories as I upgrade stuff; well and only issue to date has been the upgrade from Ubuntu 14.04 to Ubuntu 16.04 with the default of Mono going from 3.X to 4.X. (zee went from original zee to updated zee-2 and now moved over to using Ubuntu 16.04 server for the original Zee-2 HS3 software - maybe a bit overkill).
I see that you were most concerned about the Z-Wave stuff / back up.
Here base lighting network is UPB (two HS3 boxes and OP2). Z-Wave connectivity is via the GPIO z-wave card on an RPi2 and the Leviton VRCOP (connected to the Omni Pro2). X-10 on two HS3 boxes and OP2. (also utilize Zigbee).
Main heartbeat of home automated events are on the OmniPro2. Granular stuff is on the two HS3 boxes. IE: if HS3 stops; lighting schedules and scenes continue to work.
Here primarily just back up the HS3 directories as I upgrade stuff; well and only issue to date has been the upgrade from Ubuntu 14.04 to Ubuntu 16.04 with the default of Mono going from 3.X to 4.X. (zee went from original zee to updated zee-2 and now moved over to using Ubuntu 16.04 server for the original Zee-2 HS3 software - maybe a bit overkill).
Comment