Turning BLSecurity Into a Z-Wave Alarm System?

[ServiceXp]

Would it be possible to turn BLSecurity into a simple home alarm system, using z-wave devices? I installed the plug-in, but it doesn't see any of my z-wave door or motion systems.

[Blade]

You can add your zwave sensors by using the value triggered values.

[ServiceXp]

Ok, Thanks, I see that now.. I have however run into another problem.

The drop down list of devices don't show the "floor" or "Room" fields, So it's impossible for me to know where the device is located.

[Blade]

Let me check

[Blade]

Try 2.0.18 in the HS3 updater

I have added a new option on the options page to use the floor names in the devices

[ServiceXp]

Can you also add the option for Room names too?

[ServiceXp]

Spoke too soon, After ticking the new option and saving, I don't see the floor names.

[Blade]

Try 2.0.19

[ServiceXp]

It now shows, but it pushes the drop down box off screen so I can't get to any of them...

[Blade]

I wonder if you have a device in there that is causing that

[ServiceXp]

I wonder if you have a device in there that is causing that

Nothing anywhere near that long..

[Blade]

Try 2.0.20

[ServiceXp]

These create the longest string

[ServiceXp]

That one did the trick! Thanks for the changes.!!

[ServiceXp]

Well I'm running into problems in other area's now where I can't determine which sensor it is because there is no room or level label.