Go Back   HomeSeer Message Board > HomeSeer Products & Services > HomeSeer Software > Z-Tool+

Z-Tool+ Discussions about Z-Tool+ Z-Wave installation software

Thread Tools Display Modes
Old June 24th, 2016, 02:14 AM
outbackrob's Avatar
outbackrob outbackrob is offline
Seer Master
Join Date: Jun 2003
Location: El Lago, TX
Posts: 1,278
Angry That device has not been created in the plug-in.

Migrating from X-10. have been using HS3 Interface to install new Z-Wave devices. It was pretty frustrating in how you have to find things, but it worked. Installed 6 more devices today but used Z-Tool+. OMG How easy is that?!? I can add it, name it and place it in one motion!

....or so I thought. In the Z-Wave Tab, all my new devices say, "That device has not been created in the plug-in." That's it. There is no node information. They are also not controllable from the Device Management page or via control panel.

Do I need to delete these and start over? Is the Z-Tool+ ready for prime time?

Ugh. I had actually gone more than 24 hours where I wasn't completely frustrated with HS3....

Any guidance would be appreciated.
Reply With Quote


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
HS3 created device, options page won't take it completelyhis BLGarbage (3P) 0 November 26th, 2015 07:01 PM
Plug-in created Ghost players NicolaiL PI-SonosController (3P) 12 June 1st, 2015 02:31 AM
Where is the Infrared Device I created? kbrady Audio / Video and Infra-red (IR) Discussion 1 August 20th, 2011 05:11 PM
can I change the name of a device after it's created? zimmer62 Script & Plug-In Development 3 May 12th, 2008 02:55 PM
New Device created on A1 lancenorton ActiveBackup Plug-In 2 November 17th, 2005 05:49 PM

All times are GMT -4. The time now is 10:46 AM.

Copyright HomeSeer Technologies, LLC