Has anyone gotten the configuration of "0" set correctly? It is taken by HomeSeer, but never set! You can set any other configuration parameters (gets queued up for next time it is awake), but config "0" for how long to wait till it goes to off, never is able to be sent, you can't even leave config 0 blank to see what the current status of the config for parameter 0 is.
If this is your first visit, be sure to check out the FAQ. You must register before you can post.
IMPORTANT: Your first post will be checked for appropriate content. This may take a bit of time.
- If your post is deemed to be spam-free and relevant to the community, it will be approved and you'll be able to post freely here.
- If your post is deemed to be spam, your post will be deleted and your account will be permanently banned.
Comment