Fellow Homeseer Wizards-
I have an issue where I am not getting status updates on icons in homeseer when either manual or automatic event actions are taking.
Scenario:
I have Somfy RTS Blinds leveraged by a ZRTSI II controller converting to zwave
When I open a "blind" the proper status of the blind and respective icon is updated accordingly
When I have an event that opens the blind, and then after a few seconds a "STOP" command is issued, the blind stops, but the icon indicates the blind is Down vs. Open.
how can I get the status to reflect the state of the blind given for the "stop" command that is issued has a relevent status icon for it (Same as the open one)
I have attached snapshots of the icon configurations, value identifications as well as the device status on home page for references.
I have an issue where I am not getting status updates on icons in homeseer when either manual or automatic event actions are taking.
Scenario:
I have Somfy RTS Blinds leveraged by a ZRTSI II controller converting to zwave
When I open a "blind" the proper status of the blind and respective icon is updated accordingly
When I have an event that opens the blind, and then after a few seconds a "STOP" command is issued, the blind stops, but the icon indicates the blind is Down vs. Open.
how can I get the status to reflect the state of the blind given for the "stop" command that is issued has a relevent status icon for it (Same as the open one)
I have attached snapshots of the icon configurations, value identifications as well as the device status on home page for references.