I have a problem when i adjust the volume from the regular remote control. If the new volume has a value with decimal .5 (-59.5db), the volume slider goes to max.
This is info for -59,5dB:
Status 205 = Unknown
Value 205
String -59,5dB
This is info for -60,0dB:
Status 20 = Dim
Value 20 = "20"
String -60,0dB
When volume is set a value without decimals, then slider is correct again. It's a Denon 4310 receiver. I tried to switch to 0-100 mode for volume in the receiver, but it doesn't make any differences since receiver still use 0.5 steps.
This is info for -59,5dB:
Status 205 = Unknown
Value 205
String -59,5dB
This is info for -60,0dB:
Status 20 = Dim
Value 20 = "20"
String -60,0dB
When volume is set a value without decimals, then slider is correct again. It's a Denon 4310 receiver. I tried to switch to 0-100 mode for volume in the receiver, but it doesn't make any differences since receiver still use 0.5 steps.
Comment