So I decided to try my first ZWave device. I bought a CT100 thermostat along with an Aeon Labs Z-Stick II. It was a bit of a chore finding the information needed to install both devices and get them working with HomeSeer but for the most part they seem to be working in that I can view the thermostat's settings in HomeSeer and control the thermostat from HomeSeer.
But I have a couple of questions.
First, I don't understand 2 of the devices HomeSeer created after doing the import from the Z-Stick. See the image below. What are "Z-Wave Thermostat 5 Sensor Multilevel Inst 1" and "Z-Wave Thermostat 5 Sensor Multilevel Inst 2"?
Secondly, looking at the 2nd image below you'll see I am getting error messages every single time HomeSeer polls the thermostat. Obviously these messages trouble me. How do I get rid of them?
BTW, the thermostat is 3 feet from the Z-Stick with nothing but air between them.
Right now I am leaning towards replacing this thermostat with an IP stat and then figuring out how to make HomeSeer interact with it.
TIA for any wisdom you can offer.
--
Wayne
But I have a couple of questions.
First, I don't understand 2 of the devices HomeSeer created after doing the import from the Z-Stick. See the image below. What are "Z-Wave Thermostat 5 Sensor Multilevel Inst 1" and "Z-Wave Thermostat 5 Sensor Multilevel Inst 2"?
Secondly, looking at the 2nd image below you'll see I am getting error messages every single time HomeSeer polls the thermostat. Obviously these messages trouble me. How do I get rid of them?
BTW, the thermostat is 3 feet from the Z-Stick with nothing but air between them.
Right now I am leaning towards replacing this thermostat with an IP stat and then figuring out how to make HomeSeer interact with it.
TIA for any wisdom you can offer.
--
Wayne
Comment