I had to replace my RCS X10 thermostat and since they don't make them anymore, I have what appears to be an older one. The one I had came with documentation about Decode table P, 1.6. The one I just received has decode table B, 1.5. How can I tell the plug-in to use decode table b?
The one I replaced had a sequence (All Units On/Off) to select between table 2 or table 1. Is this what I do to select table b versus p? And does it stick across power on/off Homeseer reboots?
Thanks,
Dan
The one I replaced had a sequence (All Units On/Off) to select between table 2 or table 1. Is this what I do to select table b versus p? And does it stick across power on/off Homeseer reboots?
Thanks,
Dan