I just installed this plug-in and the installation and setup went perfect. I plan to drive a 4-relay module from the GPIO pins and ultimately control some security devices in the house.
I discovered during a power failure or manual reboot the internal code must go out and check each GPIO pin as my relays all go active during this time. Obviously this will not work for a security installation. Unless you have some more ideas I have determined that the only way to survive a power failure would be to install a UPS system to power the RPi. Any ideas would be welcome.
Richard
I discovered during a power failure or manual reboot the internal code must go out and check each GPIO pin as my relays all go active during this time. Obviously this will not work for a security installation. Unless you have some more ideas I have determined that the only way to survive a power failure would be to install a UPS system to power the RPi. Any ideas would be welcome.
Richard
Comment