Announcement

Collapse
No announcement yet.

X10 Controlled Relay Bank

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    X10 Controlled Relay Bank

    Just installed and tested my X10 relay bank. I was really surprised no one makes a multi-relay board for X10.

    The red area is the new stuff. It uses a CM11A outputting to an Arduino with an RS232 shield. Relay 1,2, and 3 control up/down/stop for some RollerTrol window shade motors (white box is the RollerTrol transmitter). Relay 7 runs some 12V LED strips for my equipment room. The rest are idle at the moment.

    The green area is my RGB light power and control for indirect lighting and seating cupholders. It is just run by an X10 appliance module.
    Attached Files
Working...
X