Since a couple of weeks the after command doesn't work anymore.
The before command still works, but the after command doesn't.
Offset Values:
Number of minutes before: 1
Number of minutes after: 1 v Use End Time
Before/After Commands:
HS[SetDeviceValue~A1~2]
Note: Enter one command per line followed by the enter key
After Commands:
HS[SetDeviceValue~A1~0]
These commands will override the above commands for any after offset processing.
Note: Enter one command per line followed by the enter key
Any ideas?
The before command still works, but the after command doesn't.
Offset Values:
Number of minutes before: 1
Number of minutes after: 1 v Use End Time
Before/After Commands:
HS[SetDeviceValue~A1~2]
Note: Enter one command per line followed by the enter key
After Commands:
HS[SetDeviceValue~A1~0]
These commands will override the above commands for any after offset processing.
Note: Enter one command per line followed by the enter key
Any ideas?
Comment