Announcement

Collapse
No announcement yet.

LightwaveRF light bulb and RFXCOM

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    LightwaveRF light bulb and RFXCOM

    Hi,

    just joined the Homeseer community and am finding it very good. I set up my home automation using the RFXTRX433E and the RFXCOM plug-in. Figured out how to add devices and it is working excellent!

    I stumbled upon one problem though that I can't figure out, how can I include a lightwaverf light bulb (JSJS LW560) into homeseer?

    Choosing add input device and then putting it in inclusion mode does not show any new devices.........

    Any idea's?

    Thanks for the assistance!

    #2
    Create an AD device on the Output device config page.
    See chapter 841, 8.42 and 8.43 in the RFXCOM HS3 User Guide.pdf

    Comment


      #3
      Thanks, this worked.

      I have another question.

      Which protocol do I need to enable for Livolo switches? I don't see it in the list.

      Thanks!

      Comment


        #4
        Livolo remotes are not received and Livolo modules do not transmit a status.
        As protocol enabling is only necessary for receive there is no selection for Livolo.
        Create a Livolo module or dimmer on the RFXCOM - Output devices config page.

        See also chapter 2.2.2. in the RFXtrx User Guide on the RFXCOM Downloads page, for the list of supported devices and which are transmit only, receive only or receive and transmit.

        Comment

        Working...
        X